CDA HCC663 Manual de usuario descargar pdf (Pagina 10)

How to Install the Hob

How to install the hob:

Overall dimensions of the hob: Width: 580mm Depth: 510mm

Worktop cut-out dimensions: Width: 560mm Depth: 490mm

1. Make the required hole in the worktop. Before doing this, you must check

the instructions supplied with any cooker hood to ensure that you will have

the required clearance. The cut-out (Fig.4) shows a 60mm gap from the wall

to the cut-out edge. The distance from the hob, when ﬁtted, to the back

wall is 50mm. If a splashback/worktop upstand is to be ﬁtted, take this into

account when cutting the hole. The minimum distance that the hob should be

positioned away from the rear wall or splashback is 50mm.

2. Position the hob seal, as shown in Fig.6, ensuring that the ends meet without

overlapping. Do not use silicone type sealant.

3. Secure the hob to the worktop using brackets and screws supplied, as shown

in Fig.7. Remove any excess sealant after tightening the brackets. Do

not over-tighten the ﬁxing brackets.

3cm

4cm

65mm

470mm

550mm

150mm150mm

Fig.4

Fig.5

400mm

60mm

480mm

560mm

190mm190mm

Fig.6

Fig.7

650mm (600mm minimum)

1 2 ... 5 6 7 8 9 10 11 12

Sin comentarios

CDA HCC663 Manual de usuario Pagina 10