CDA hc7620 Manual

hc7620 Built-In Ceramic Hob Manual for Installation, Use and Maintenance

10 To Unlock the Controls: Touch and hold the key lock control for approx. 2 seconds. The controls are now unlocked and the ceramic hob is ready

11 Using the Timer You can use the timer in two different ways: • You can use it as a minute minder. In this ca

12 seconds and the timer indicator shows “- - “. To cancel the beep touch both the “+” and “-“ controls together. To cancel the timer (at any poin

13 When the cooking time is reached, the corresponding cooking zone will switch off automatically and the beeper will sound a single beep.

14 Efficient Use of Your Hob Before using your hob for the first time, switch the zones on for a FEW SECONDS to burn off any grease left over from t

15 suitable material and have the correct type of base. The base should be flat and smooth, as any rough part on the pan base could scratch the cera

16 Care and Maintenance Always disconnect the appliance from the power supply before undertaking any cleaning or maintenance. You should use a non-

17 Troubleshooting Below is a list of some of the possible malfunctions. If the problem cannot be resolved as described, contact Customer Service

18 Important: Steam cleaners must not be used when cleaning this appliance. Mains Electricity Connection Mains electrical voltage: 220 – 240V

19 Please note: • The mains cable must only be replaced by a qualified electrician or service engineer and must be of equivalent or better rating (

2 Contents Contents ... 2 Important ...

20 Fitting the Hob Unpacking the Hob: • Take care not to lose or mishandle any parts. Fitting Position of the Hob: This appliance must be installed

21 shelf should be fitted to protect the user from high temperatures. • If the hob is to be installed above a working drawer, then a partition shou

22 How to Install the Hob Overall dimensions of the hob: Width: 770mm Depth: 520mm Worktop cut-out dimensions: Width: 750mm Depth: 495mm 1. Make

23 NOTES:-

24

25 4. brackets.

3 Important The CDA Group Ltd cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note

4 At the end of its working life, the product must be taken to a special local authority waste collection centre or to a dealer providing appliance

5 • The appliance is not intended to be operated by any means of an external timer or separate remote-control system. Important Note Do not use th

6 Control Panel: 1 3 2 4 5 1 1. Heating zone controls 2. Time

7 To Switch Heating Zones On When the mains power supply is switched on, the buzzer beeps once and all the indicators light up for 1 second, then go

8 To Switch Heating Zones Off Turn an individual cooking zone off by using the “+” or “-“ controls to scroll down to “0“. Alternatively, the zone m

9 zone indicator will flash between the power setting and . Touch the triple zone control again and this will switch to all three areas heating