CDA RC 9621 Series Manual de servicio descargar pdf (Pagina 10)

Electronic Clock (g. 4)

The programmer is equipped with an electronic clock with illuminated numbers which indicates hours

and minutes. Upon immediate connection of the oven or after a power cut, three zeros will ash on the

programmer display.

To set the correct time of day it is necessary to push the

button and then the or button until you

have set the correct time. In another way push simul tane ously the two buttons and at the same time

push the or button.

Note: If the clock is reset it deletes any previously set programs.

Normal Cooking without the Use of the Programmer

To manually use the oven, that is, without the aid of the programmer, it is necessary to cancel the ashing

AUTO by pushing the button

(AUTO will be switched o and the symbol will go on - Fig. 5).

Attention: If the AUTO is steadily lit (which means a cooking program has already been set), the program can

be cancelled and switched to manual by pushing the button .

If the oven is switched on, you must switch o manually.

Electronic Timer

The timer program consists only of a buzzer which may be set for a maximum period of 23 hours and 59

minutes. If the AUTO is ashing push the button.

To set the time, push the button and the or until you obtain the desired time in the panel (g. 6).

Having nished the setting, the clock hour will appear on the panel and the symbol will be illuminated.

The countdown will start immediately and may be seen at any moment on the panel by simply pressing the

button .

At the end of the time, the symbol will disappear and the buzzer will sound and continue for approximately

7 minutes or until a button is pressed (not the / buttons).

After a short time the display will revert back to the time of day.

Setting the Frequency of the Audible Signal

The buzzer has 3 dierent tones and can be changed by pressing the button, but only when the time of

day is displayed.

Fig. 5 Fig. 6

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

Sin comentarios

CDA RC 9621 Series Manual de servicio Pagina 10