
6
Use
Humidity Control
The wine coolers are equipped with a humidity control
system to maintain optimal humidity within the wine cooler.
Fill the humidity reservoir approximately 3/4 full with water.
Place the reservoir on the runners on the top shelf as
shown in fig. 5. Ensure it is located correctly to prevent
water spillage.
Check the water level regularly and refill if required.
Temperature display
The temperature display will show the current internal temperature.
The display flashes:
• When a dierent temperature is being set
• If the internal temperature is +/- 5˚ away from the set temperature. This serves as a warning to prevent damage to the
contents of the appliance should the temperature be too high.
Dynamic Cooling and Silent modes
The appliance has two dierent running modes.
• Silent mode
Once the required temperature is reached, the appliance will run without the fan.. The wine cooler is factory set to silent
mode.
To change to dynamic cooling mode, touch and hold the down key for approximately five seconds. The wine cooler will
beep five times to confirm dynamic cooling is on.
• Dynamic cooling mode
The fan cycles on and o to circulate the air even after the required temperature is reached. This ensures consistent
humidity and temperature distribution in the wine cooler, creating perfect conditions for long term storage.
Using the dynamic mode increases the level of noise in operation.
To change to silent mode, touch and hold the up key for approximately five seconds. The wine cooler will beep three times
to confirm silent mode is on.
Sabbath mode
Sabbath mode is available for the observance of certain religious holidays. This will switch o the displays, interior light
and audible alarms. The cooling process will continue.
To switch the Sabbath mode on, touch and hold the power and light keys simultaneously for five seconds. The indicator
light will flash four times and confirm the Sabbath mode is on. Sabbath mode will switch o automatically after 96
hours, but to switch the Sabbath mode o at any time, touch and hold the power and light keys simultaneously for five
seconds.
fig. 3
Comentarios a estos manuales