CDA hn6410 Manual Pagina 1

IMPORTANT: PLEASE REFER TO PAGE 20 FOR INFORMATION ON CONFIGURING THE POWER CONSUMPTION MODE CORRECTLY. THE HOB MUST BE CONFIGURED AT FIRST SWITCH ON

10seconds remaining. At the end of the timer, the selected zone will switch o and the timer display and the zone timer LED will flash. The hob will

11childlock is switched o.Use of the childlock when the hob is oThe childlock LED is illuminated to show the childlock is on.Use of the childlock wh

12Small object safetyAnything left on the control panel (e.g. cutlery or towels) will cause the hob to switch o automatically and there will be a bee

13Ecient Use of Your HobThe hob is equipped with zones of dierent sizes, designed to accommodate most shapes and sizes of pan. For best results, on

14Care and MaintenanceAlways disconnect the appliance from the power supply before undertaking any cleaning or maintenance.Important: • Steam cleaner

15In the event of a fault with the hob, please advise CDA Customer Care of any fault code shown on the displayContact CDA Customer CareA : Customer Ca

16IMPORTANT - PLEASE NOTE: In the event of any breakage, crack or cracking – even minimal – of the vitroceramic glass, immediately disconnect your app

17Fitting the HobUnpacking the hob:Take care not to lose or mishandle any parts.Fitting position of the hob:This appliance must be installed a minimum

18recommended) (Fig. 4). If the instructions supplied with the hood dictate that the hood must be installed at a height greater than 600mm, then that

19How to Install the HobOverall dimensions of the hob:Width: 580 mm Depth: 510 mmWorktop cut-out dimensions:Width: 560 mm Depth: 490 mm1. Make t

2ImportantThe CDA Group Ltd cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note th

20Power CongurationThis hob can be connected to a 13, 16, 25 or 32Amp supply and configured to work on any of these power settings. If the hob is conn

21Mains Electricity ConnectionWarning! this appliance must be earthedWe recommend that the appliance is connected by a qualified electrician, who is a

223.5kW-7.2kW modes When configured in any mode other the 2.8kW, the hob should be installed into a dedicated cooker outlet and protected by the size o

23

Please contact our Customer Care Department for Service on the details belowCustomer Care Department • The Group Ltd. • Harby Road • Langar •

32004/108/EC. Parts intended to come into contact with food conform to 89/109/EC.IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDAN

4• Do not place hot lids flat on the hob top. A “suction” eect could cause damage to the hob.• Do not drag cookware across the hob top: in the lo

5Important• Do not use the hob if the glass surface is cracked or damaged to prevent the risk of electric shock. Disconnect it from the power suppl

6Cooking on InductionThe principle of induction cooking is based on magnetic eect.When you put your cookware on an induction zone and switch it on, t

7Using Your Hob The table below oers guidance as to what each power level is for.Power level Type of cooking0 Switched o1/2 Melting (butter/choco

8Using Your HobTo switch the hob onTo switch the power on, touch and hold the key for approximately two seconds. The hob will beep and all four zone

9BoosterThe hob is equipped with a booster function, allowing a higher power level than the maximum for approximately ten minutes. To turn on the boo