CDA HCG 730 Users operating instructions El manual del propietario descargar pdf (Pagina 119)

Steps

1. Locate the USB connector or USB key on the system board.

NOTE: To locate the internal USB connector on the system board, see System board

connectors .

2. If installed, remove the USB key.

3. Insert the new USB key into the USB connector.

Figure 53. Replacing the internal USB key

1. USB memory key 2. USB memory key connector

Next steps

1. Follow the procedure listed in After working inside your system.

2. While booting, press <F2> to enter the System Setup and verify that the USB key is detected by the

system.

System battery

Replacing the system battery

Prerequisites

1. Ensure that you read the Safety instructions.

2. Follow the procedure listed in Before working inside your system.

3. Remove the cooling shroud.

WARNING: There is a danger of a new battery exploding if it is incorrectly installed. Replace the

battery only with the same or equivalent type recommended by the manufacturer. See your

safety information for additional information.

119

1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 207 208

Sin comentarios

CDA HCG 730 Users operating instructions El manual del propietario Pagina 119