CDA HCG 730 Users operating instructions El manual del propietario descargar pdf (Pagina 121)

Figure 55. Installing the system battery

1. system battery 2. positive side of the battery connector

Next steps

1. Install the cooling shroud.

2. Follow the procedure listed in After working inside your system.

3. While booting, press <F2> to enter the System Setup and ensure the battery is operating properly.

4. Enter the correct time and date in the System Setup Time and Date fields.

5. Exit the System Setup.

Power supply units

Your system supports one of the following:

• Two 495 W, 750 W, or 1100 W AC power supply modules or

• Two 1100 W DC power supply modules or

• Two 750 W mixed mode power supply modules

NOTE: Titanium power supply unit is nominally rated for 200 VAC to 240 VAC input only.

NOTE: When two identical power supplies are installed, power supply redundancy (1+1 – with

redundancy or 2+0 – without redundancy) is configured in system BIOS. In redundant mode, power

is supplied to the system equally from both power supplies when Hot Spare is disabled. When Hot

Spare is enabled, one of the PSUs will be put into standby when system utilization is low in order to

maximize efficiency.

NOTE: If two power supply units are used, they must be of the same maximum output power.

NOTE: For AC power supply units, use only power supply units with the Extended Power

Performance (EPP) label on the back. Mixing power supply units from previous generations of

servers can result in a power supply unit mismatch condition or failure to power on.

121

1 2 ... 116 117 118 119 120 121 122 123 124 125 126 ... 207 208

Sin comentarios

CDA HCG 730 Users operating instructions El manual del propietario Pagina 121